STEF05DPUR

STMicroelectronics
511-STEF05DPUR
STEF05DPUR

Nsx:

Mô tả:
Hot Swap Voltage Controllers Electronic fuse for 5 V line

Mô hình ECAD:
Tải xuống Thư viện Tải miễn phí để chuyển đổi tệp tin này cho Công cụ ECAD của bạn. Tìm hiểu thêm về Mô hình ECAD.

Có hàng: 2,765

Tồn kho:
2,765 Có thể Giao hàng Ngay
Thời gian sản xuất của nhà máy:
24 Tuần Thời gian sản xuất tại nhà máy dự kiến để có số lượng lớn hơn mức hiển thị.
Tối thiểu: 1   Nhiều: 1
Đơn giá:
$-.--
Thành tiền:
$-.--
Dự kiến Thuế quan:
Đóng gói:
Toàn bộ Cuộn (Đơn hàng theo bội số của 3000)

Giá (USD)

Số lượng Đơn giá
Thành tiền
Cut Tape / MouseReel™
$1.20 $1.20
$0.866 $8.66
$0.784 $19.60
$0.693 $69.30
$0.672 $168.00
$0.659 $329.50
$0.618 $618.00
Toàn bộ Cuộn (Đơn hàng theo bội số của 3000)
$0.537 $1,611.00
$0.534 $3,204.00
† $7.00 Phí MouserReel™ sẽ được thêm và tính vào giỏ hàng của bạn. Không thể hủy và gửi trả tất cả đơn hàng MouseReel™.

Đặc tính Sản phẩm Thuộc tính giá trị Chọn thuộc tính
STMicroelectronics
Danh mục Sản phẩm: Bộ điều khiển điện áp hoán đổi nóng
RoHS:  
Power Distribution
4 A
10 V
- 300 mV
1 Channel
3.6 A
- 40 C
+ 125 C
SMD/SMT
DFN-10
Reel
Cut Tape
MouseReel
No
Nhãn hiệu: STMicroelectronics
Quốc gia Hội nghị: Not Available
Quốc gia phân phối: Not Available
Quốc gia xuất xứ: SG
Nhạy với độ ẩm: Yes
Loại sản phẩm: Hot Swap Voltage Controllers
Sê-ri: STEF05D
Số lượng Kiện Gốc: 3000
Danh mục phụ: PMIC - Power Management ICs
Đơn vị Khối lượng: 50 mg
Đã tìm thấy các sản phẩm:
Để hiển thị sản phẩm tương tự, hãy chọn ít nhất một ô
Chọn ít nhất một hộp kiểm ở trên để hiển thị các sản phẩm tương tự trong danh mục này.
Các thuộc tính đã chọn: 0

CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
JPHTS:
854239099
TARIC:
8542399000
MXHTS:
8542399901
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.